Motomaster eliminator 700a booster pack manual

Motomaster eliminator 700a booster pack manual manual#

Always wear eye protection when working with batteries.

Always ensure someone is nearby to help you in an emergency.

To prevent the risk of fire or an explosion, always operate in a well-ventilated area and follow all safety information instructions.

Batteries generate hydrogen gas during normal operation which can be ignited by sparks from electrical connections.

The battery booster pack contains components that tend to produce arcs or sparks.

NEVER allow the red and black clamps to touch each other or a common piece of metal.

NEVER attempt to jump-start a frozen battery.

DO NOT expose the unit to extreme heat, fire, or incineration.

DO NOT operate the unit near the presence of flammable/combustible liquids or gases.

Attempting to service the unit yourself may result in a risk of electrical shock or fire and will void the warranty.

Motomaster eliminator 700a booster pack manual manual#

Refer to the warranty section of this manual for instructions on obtaining service.

DO NOT disassemble the unit the unit should only be serviced by a qualified technician.

DO NOT operate the unit if it has received a sharp blow, been dropped, or otherwise damaged in any way.

Product is an electrical device that can produce shock and cause injury if used in wet environments.

DO NOT expose the product to rain, snow, or use in damp conditions.

Dispose of the product according to local regulation at end of product life.

The product contains a lithium-based battery.

If this unit is leaking liquid dispose of it at the proper recycling facility immediately.

DO NOT store in locations where the temperature may exceed 35 ☌ (95 ☏).

This unit is not for use by children and should only be operated by adults.

DO NOT insert foreign objects into either USB port.

Ensure that there are no USB devices connected to the battery booster pack while the unit is being recharged.

This may lead to accumulation of hydrogen, causing exposure to fire and explosion hazards.

DO NOT charge the unit through the 12V DC charging port if your vehicle’s electrical system operates above 15 V.

Charge only at ambient temperatures between 0☌ and 45☌ (32☏ and 113☏).

DO NOT use the unit to jump-start a vehicle while charging the internal battery.

Always turn the unit off when not in use.

Allow the battery booster pack to cool down for at least 3 minutes after each boost. Operating the jump start feature for more than 3 seconds may cause damage to the unit. The jump start feature is designed for short-term operation only.

Do not crank the engine for more than 3 seconds at a time.

The cable clamps connecting the boosting cables to the vehicle’s battery terminals must be positive to positive (red clamp to battery “+”) and negative to negative (black clamp to battery “-”).

MotoMaster is not responsible for user safety or damage when using accessories not approved by MotoMaster.

Use only the jumper cables provided with this unit.

DO NOT attempt to operate a vehicle that does not have a battery installed.

This unit is not intended to be used as a replacement vehicle battery.DO NOT attempt to use products with any other battery types. This product is only compatible with 12V lead-acid batteries.

Failure to follow these safety instructions may cause ELECTRIC SHOCK, EXPLOSION, or FIRE, which may result in SERIOUS INJURY, DEATH, or PROPERTY DAMAGE. Read and understand all safety information before using this product. This jump starter generates a high current of up to 600 peak Amps.